The Federal Board of Revenue (FBR) has ordered iron and steel manufacturers to install electronic production monitoring systems at every manufacturing facility and active production line by Dec. 30, 2026, as the government moves to digitally monitor output and dispatches in the sector.
In a statement, the FBR said the order applies to registered manufacturers involved in melting ferrous scrap, direct reduced iron, sponge iron and other ferrous inputs to produce billets, ingots and primary steel products. It also covers manufacturers that reheat, roll or re-roll semi-finished steel into bars, reinforcing bars, rods, sections and other finished products, as well as composite units carrying out melting, casting and rolling at the same premises.
The directive was issued under Section 40C(2) of the Sales Tax Act, 1990, read with relevant provisions of the Sales Tax Rules, 2006, and SRO 880(I)/2026 dated May 20, 2026. The order takes effect immediately.
The FBR said manufacturers must procure, install, integrate, test and operationalize the monitoring system within the deadline. Equipment and software must be obtained and maintained through vendors authorized by the board under the relevant sales tax rules.
Under the new arrangement, electronic monitoring will cover production stages from the identification and counting of billets and ingots to the verification of finished products and the recording of dispatch weights. At melting units, monitoring equipment will be installed at continuous casters, mold-discharge points or cooling areas to identify and count individual billets and ingots. The system will record production time, dimensions, production lines and batch references, where available, and estimate the weight of output using prescribed parameters.
At rolling mills, monitoring points will verify product dimensions, including the diameter, section and profile being manufactured. Cameras and analytics software will also count finished steel products at cooling beds before they enter bundling areas, classifying them by size and length and calculating their estimated weight.
The fourth stage will integrate dispatch weighbridges with the monitoring system. The FBR said the system must capture gross, tare and net weights, vehicle registration numbers, timestamps, product categories and other available dispatch references.
It will then reconcile actual dispatched weights with production estimates recorded at earlier stages and flag discrepancies exceeding tolerances prescribed by the board.
The number of monitoring stages will depend on the manufacturing process. Melting-only and re-rolling-only facilities will use configurations appropriate to their operations, while composite units will require a four-stage system covering melting, rolling, finished-product counting and dispatch verification.
The minimum equipment requirements include industrial cameras, network video recorders with at least one month of local storage, computing equipment for video analytics, production-line sensors, weighbridge interfaces, backup power and secure network connectivity. Systems must also retain data during connectivity interruptions and transmit it automatically when connections are restored.
The FBR said production and dispatch information must be transmitted in real time to its Central Control Unit, alongside secure storage of prescribed video footage, images, event data and system logs.
The systems must detect production stoppages, data gaps, equipment failures, obstruction, unauthorized changes and suspected tampering. Manufacturers must also maintain audit trails covering calibration, software configurations and changes to production parameters.
The board said cameras, measurement devices, weighbridge interfaces and analytics models must be calibrated and validated against controlled production and dispatch samples. Weight-conversion tables, product-size mappings and tolerance limits must be approved or accepted by the FBR before the system becomes operational.
The directive establishes a digital framework for comparing reported production with actual dispatches, allowing the tax authority to identify discrepancies and strengthen oversight of sales tax reporting in the iron and steel industry.


